-
Notifications
You must be signed in to change notification settings - Fork 13.3k
Closed
Labels
waiting for feedbackWaiting on additional info. If it's not received, the issue may be closed.Waiting on additional info. If it's not received, the issue may be closed.
Description
Basic Infos
- This issue complies with the issue POLICY doc.
- I have read the documentation at readthedocs and the issue is not addressed there.
- I have tested that the issue is present in current master branch (aka latest git).
- I have searched the issue tracker for a similar issue.
- If there is a stack dump, I have decoded it.
- I have filled out all fields below.
Platform
- Hardware: [ESP-12|ESP-01|ESP-07|ESP8285 device|other]
- Core Version: [0fd86a0]
- Development Env: [Platformio]
- Operating System: [Windows|Ubuntu]
Settings in IDE
- Module: [Generic ESP8266 Module|other]
- Flash Mode: [dio]
- Flash Size: [4MB/1MB]
- lwip Variant: [PIO_FRAMEWORK_ARDUINO_LWIP2_LOW_MEMORY_LOW_FLASH]
- Reset Method: [-]
- Flash Frequency: [40Mhz]
- CPU Frequency: [80Mhz]
- Upload Using: [OTA|SERIAL]
- Upload Speed: [115200] (serial upload only)
Problem Description
Loop Count in loops per sec. is much lower than with core 2.4.2. It was also mentioned here: #5476 (comment)
I have several test setups running core 2.4.2 and core 2.5.0 (see latest nightly builds of ESPeasy)
For example 2 Sonoff POW r2 nodes running the exact same configuration, the loopcount (per sec) of both differs quite a lot:
N.B. Not sure yet why in the node running 2.4.2 less things are being shown.
In general (among my test nodes) the loop-count is:
- 4000 - 11000 when using core 2.4.2
- 1100 - 2300 when using core 2.5.0 (4200 when doing nothing)
As can be seen from both Sonoff POW r2 nodes, the loop-count is:
- 4200 for core 2.4.2
- 1148 for core 2.5.0
Metadata
Metadata
Assignees
Labels
waiting for feedbackWaiting on additional info. If it's not received, the issue may be closed.Waiting on additional info. If it's not received, the issue may be closed.