'esp32_adc2gpio' was not declared while compiling for um_tinys3 #7516
Description
Board
Unexpected Maker TinyS3 (AKA: TinyS3)
Device Description
N/A
Hardware Configuration
N/A
Version
latest master (checkout manually)
IDE Name
PlatformIO
Operating System
Windows 11
Flash frequency
80Mhz
PSRAM enabled
yes
Upload speed
921600
Description
Everytime I try to compile for the TinyS3 using PlatformIO, it fails saying that error: 'esp32_adc2gpio' was not declared in this scope.
The only workaround for that is to edit manually variants/um_tinys3/pins_arduino.h commenting out the line 16 (#define analogInputToDigitalPin(p) (((p)<20)?(esp32_adc2gpio[(p)]):-1)) and add #define analogInputToDigitalPin(p) (((p)<20)?(analogChannelToDigitalPin(p)):-1) just below of it
Please refer to wled/WLED#2905 (comment) for more info
Sketch
//sketch.ino:
#include <Arduino.h>
void setup() { }
void loop() { }
//platformio.ini:
[env:esp32s3dev_8MB_PSRAM]
;; ESP32-TinyS3 development board, with 8MB FLASH and 8MB PSRAM (memory_type = qspi_opi)
board = um_tinys3
platform = [email protected]
platform_packages =
upload_speed = 921600
build_unflags = ${common.build_unflags}
build_flags = ${common.build_flags} ${esp32s3.build_flags}
-D CONFIG_LITTLEFS_FOR_IDF_3_2 -D WLED_WATCHDOG_TIMEOUT=0 -D ARDUINO_USB_MODE=1 -D ARDUINO_USB_CDC_ON_BOOT=0 -D ARDUINO_USB_MSC_ON_BOOT=0
-D WLED_USE_PSRAM
lib_deps = ${esp32s3.lib_deps}
board_build.partitions = tools/WLED_ESP32_8MB.csv
board_build.f_flash = 80000000L
board_build.flash_mode = qio
monitor_filters = esp32_exception_decoderDebug Message
C:/Users/juanp/.platformio/packages/framework-arduinoespressif32/variants/um_tinys3/pins_arduino.h:16:48: error: 'esp32_adc2gpio' was not declared in this scope
#define analogInputToDigitalPin(p) (((p)<20)?(esp32_adc2gpio[(p)]):-1)
wled00/src/dependencies/blynk/Blynk/BlynkApiArduino.h:70:62: note: in expansion of macro 'analogInputToDigitalPin'
#define BLYNK_DECODE_PIN(it) (((it).asStr()[0] == 'A') ? analogInputToDigitalPin(atoi((it).asStr()+1)) : (it).asInt())
^~~~~~~~~~~~~~~~~~~~~~~
wled00/src/dependencies/blynk/Blynk/BlynkApiArduino.h:93:19: note: in expansion of macro 'BLYNK_DECODE_PIN'
uint8_t pin = BLYNK_DECODE_PIN(it);
Other Steps to Reproduce
You can fork https://github.com/Aircoookie/WLED and replace the [env:esp32s3dev_8MB_PSRAM] from that project with the above one
I have checked existing issues, online documentation and the Troubleshooting Guide
- I confirm I have checked existing issues, online documentation and Troubleshooting guide.